+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: Ask Your question... (/forumdisplay.php?fid=45)
+--- Thread: Leaking output shaft seal (/showthread.php?tid=6524)
Pages: 1 2
RE: Leaking output shaft seal - Chamberpains - 08-24-2020
That electric half inch impact that kozakvod posted ain't gonna cut it for this type of job. They do make 3/4" and 1" electric impacts. Guys have told me they handle lug nuts nicely. I dont know about the bigger input/output/ intermediate/through shaft nuts. They are big and so are the sockets. Like flatbed94kid said a torch is sometimes needed to cut or heat them enough to get them off. Or one of the torque multipliers and a long cheater bar. But don't reuse the nut. Throw it away. They are almost always one time use.
RE: Leaking output shaft seal - Waterloo - 08-24-2020
When I had my seals replaced, they used a 1 inch gun. A shop is the best place to have this type of work done if you do not have the proper tools. JMHO