+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: Ask Your question... (/forumdisplay.php?fid=45)
+--- Thread: X15 Returning fault 2692 (/showthread.php?tid=9107)
Pages: 1 2
RE: X15 Returning fault 2692 - Rawze - 09-23-2023
(09-23-2023 )Innocent Bystander Wrote: Have you dealt with this broken/missing baffle on the DOC before? New one is now over $6000.
The baffle itself is used to help evenly disburse the exhaust flow across the DOC.
I suppose it would depend on how much of it had broken out, and how unevenly the exhaust flow would likely become, before I did anything about it.
RE: X15 Returning fault 2692 - marek4792 - 09-23-2023
Just got my filter baked and found the same piece laying inside my DOC too. Hasn't harmed anything.
RE: X15 Returning fault 2692 - amermextrucker - 06-10-2025
Just got this code , truck started acting crazy today , truck would jerk and sputter when up shifting once in gear it will rev up , it happens mostly below 1500 rpms
Doesn't matter if loaded or empty, especially in gears 7,8 &9
.
Recently did clutch job the whole thing , rear structure reseal and etc... at first I'm thinking clutch was slipping , but having seen code now I'm having second thoughts.
Also NO CEL light is on dash for code 2692.
Prior to putting truck on the road I did an egr tune up and cleaned crossover pipe.
RE: X15 Returning fault 2692 - amermextrucker - 06-11-2025
Also truck is doing Regens every 100 hrs the last one yesterday was at 110 hrs , after regen egr differential pressure was reading 1.3 in hg .
RE: X15 Returning fault 2692 - Rawze - 06-11-2025
(06-10-2025 )amermextrucker Wrote: Just got this code , truck started acting crazy today , truck would jerk and sputter when up shifting once in gear it will rev up , it happens mostly below 1500 rpms
Doesn't matter if loaded or empty, especially in gears 7,8 &9
.
Recently did clutch job the whole thing , rear structure reseal and etc... at first I'm thinking clutch was slipping , but having seen code now I'm having second thoughts.
Also NO CEL light is on dash for code 2692.
Prior to putting truck on the road I did an egr tune up and cleaned crossover pipe.
maybe it needs a new engine harness?.
is there an e-log or other device on the network acting up ?... or maybe drive it with it unplugged and see if it acts up?.
RE: X15 Returning fault 2692 - amermextrucker - 06-11-2025
No elog , there is a GPS module with a GPS fault light , but light is not on .would code 2692 cause the truck to jerk and rev like it didn't catch a gear ?