Isx oil prime - Printable Version +- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums) +-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1) +--- Forum: ISX Related Help (/forumdisplay.php?fid=68) +--- Thread: Isx oil prime (/showthread.php?tid=8129) |
Isx oil prime - Jchism3406 - 03-27-2022 What is needed to prime the oil system On a cm570 through the oil cooler RE: Isx oil prime - Signature620 - 03-27-2022 Just once or to set up a primer system for frequent use? RE: Isx oil prime - Rawze - 03-27-2022 If you are referring to priming it after an in-frame or rod/main bearing replacement ... here is an older video where i used a 12-volt pump to do it on my own truck. Starts at about 1:50 minutes into the video ... I use a 120-volt pump nowadays and a bit better method ... When I am helping someone here, I use this one to prime the engine after a rebuild or replacing rod/main bearings... https://amzn.to/3uzy22m I made an adapter for it that fits into the large oil pressure relief valve plug just above the oil filter (to get a better volume of oil flowing thru the engine). I remove the oil-pan drain plug, I also remove relief valve the plug, and the guts of the relief valve. Then I connect up the pump to the large opening of the relief valve plug. I use a catch pan under the oil pan and pump the oil in. It circulates thru the engine and back down into the catch pan. I let it circulate for a good 10 minutes or so, flushing and lubricating the engine any time major work is done where the engine might have a chance possible to dry-start. I also bar the engine over by hand while doing this. That is just how I do it any ways. RE: Isx oil prime - Jchism3406 - 03-27-2022 Yes just once after over haul thank you |