Rawze.com: Rawze's ISX Technical Discussion and more
Egr codes cm 870 after rebuild - Printable Version

+- Rawze.com: Rawze's ISX Technical Discussion and more (http://rawze.com/forums)
+-- Forum: Big Truck Technical Discussion... (/forumdisplay.php?fid=1)
+--- Forum: ISX Related Help (/forumdisplay.php?fid=68)
+--- Thread: Egr codes cm 870 after rebuild (/showthread.php?tid=9188)



Egr codes cm 870 after rebuild - Benjamin9669 - 11-02-2023

Egr out of calibration.
Truck runs like a dream after rebuild. At idle it will whistle stop whistle stop whistle stop followed by a check engine light and than it will go off, than going down the road it will boost 36-37psi in 13 or when it boosts a bit it’ll throw a cel. But the only codes is for egr. Main one is egr out of calibration. Maybe rawze would have some input on this?


RE: Egr codes cm 870 after rebuild - Rawze - 11-02-2023

egr valves on CM870's are notorious for sticking. Maybe take it off and clean it, ensure it is operating normally.

Also check the EGR Delta-P sensor and tube that feed it.