| Tools |
| 09-27-2016, (Subject: Tools ) Post: #19 | |||
| |||
RE: Tools (09-26-2016 )Signature620 Wrote: Can anybody give a comparison between Snap On and IR 3/4" air impacts? I've seen countless Snap Ons that can barely make the torque-turn on ISX head and main bolts. The only difference I can see is several hundred $$$ . IR probably makes the snap on impacts, don't know that for a fact. I've talk to a few guys that bring in piggyback tractors, all of them used the 3/4" IR to dismount and install tires. Good enough to get them on the ground, then final torque. User's Signature: 2010 386 Pete CM871, 13 spd. 3.55 | |||
| 09-27-2016, (Subject: Tools ) Post: #20 | |||
| |||
RE: Tools (09-26-2016 )Signature620 Wrote: Can anybody give a comparison between Snap On and IR 3/4" air impacts? I've seen countless Snap Ons that can barely make the torque-turn on ISX head and main bolts. I don't use air tools except for the main bearings. it is just too problematic to use wrenches and a torque amplifier upside down under the truck. You end up trying to sling around 20-lbs of wrench and 4 feet of cheater pipes just do the final torque. got this one... http://www.northerntool.com/shop/tools/p..._200655835 It will put them in with no problem, but I have the air pressure on the compressor turned up to 150 PSI and feed it with 1/2 line WITHOUT quick-connects, but hydraulic pipe unions instead... https://amzn.com/B00D3CU5YI User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!. | |||
(Online)| « Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.