Just did 2 injectors ran2 days now skipping

[earnies2]

(01-01-2017 )Rawze Wrote:  

(12-31-2016 )Hammerhead Wrote:  Thanks for the update, I will update my procedure printout!
I couldn't agree more on a set torque spec. There are items where torque plus angle is necessary, but Cummins seems to really overuse it IMHO.
I could feel that 70 was a fair amount less than the procedure, but I've checked mine a couple of times and they haven't been loose, so I've left well enough alone. I'm planning on replacing a couple injectors shortly, so I'll put this new info to use!

Just remember that you want to wick out any oil from the holes before installing the bolts. I have seen that mistake before, and the results are sometimes not pretty.

I made sure all the bolt holes were cleaned out and blown out And i was told the rocker arm shafts were torqued at 120