2250 Carnage Pictures

[Shipit]

Just checked mine . Fuel line banjo seals needed : two 3963990 and two 3963988 . they were like 3 bucks a piece it wasn't real clear which ones you needed when looking at it on quickserve. Also the instructions has you remove the actuator from the side of the head to blow shop air in a port to push the plungers out . I didn't have to remove it because mine were extended. The instructions have you quickly push them in and check that the plungers bounce back to verify proper operation. Note if you slowly push them in they will not return then you might have to remove the actuator to blow them back out . So it might be a good idea to look up that actuator gasket part no. while getting the head gasket. You need a good quality 12 point 10 mm socket. Torque valve on those head bolts was like 60 lbs. Not a job for 1/4 drive!