Cummins ISM not reading boost correctly?
02-24-2017, (Subject: Cummins ISM not reading boost correctly? ) 
Post: #5
RE: Cummins ISM not reading boost correctly?
Scan gauge boost is electronically calculated, not actual.
Did you replace delta P (pressure differential sensor?)? The one with 2 tubes on the intake manifold.
Those tubes are notorious for clogging on the Isx and Ism. You can't clean the sensor, only replace.
It's a key sensor and can throw ecm function. Does it cough or sneeze? I don't know how else to describe it,
thats what it sounds like, very quick interruption in power. Some call it turbo cough.
I had that problem with the Ism I use to run, egr tune up cured it.

While your at it, exhuast gas pressure sensor should be replaced too.
They're about $80-90.
Other than that I would check for leaks in CAC that my be showing at high boost.


User's Signature: 2010 386 Pete CM871, 13 spd. 3.55
replyreply


Messages In This Thread
RE: Cummins ISM not reading boost correctly? - in2trux - 02-24-2017



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.