Crankshaft endplay

[Rawze]

(03-31-2017 )race7820000 Wrote:  I need to get a dial indicator tomm, my endplay is more than .020 though cause I can see it move, it looks like alot but the only way to know iso with the right tools. I pulled the pan off and I have to get a socket for my 1 inch impact tomm also cause I can't break a main cap loose. I did pull a rod bearing and here is what it looked like. I didn't think it looked to bad for having 1.1 mil miles.

The lower rod bearings don't usually wear that much. Check the upper rod bearings.