Cm2250 vgt Turbo actuator problem

[antman529]

(03-06-2017 )CumminsFreak Wrote:  

(03-06-2017 )stallyn Wrote:  Hi, i would personally start with the aftertreatment issue first hand, as the derate is probably caused by that code.

Stallyn thank you for the response. I got the actuator to install and calibrate in insite because the cummins insite I had installed for quite some time on my laptop was out dated, with 7.5 version and not 7.6+ version.. I took out the scr and def filters, the second one seemed to be cracked and might be causing my problems..
Can 0125 fault code be in anyway related to aftertreatment problems? Or am I looking for two separate problems?

I'm having the same issue when trying to do the install of my actuator using Inside 7.6.2 sp5. When I start the install command, all I ever see is the blue bar scrolling across the screen and the install never passes or fails. Can you give more detail on how you were able to correct that problem?

Is there an INCAL file that is required for the actuator install to run correctly?

I would appreciate any advice. I have watched the video of Rawze doing the install and calibration but I can't get passed the install step.