Rawze.com: Rawze's ISX Technical Discussion and more / Big Truck Technical Discussion... / ISX Related Help / New vibration damper?

new reply
New vibration damper?
05-23-2017, (Subject: New vibration damper? ) 
Post: #13
Hammerhead Offline
Kookoo for Cocoa Puffs  (1922 Likes)  *****

 		Posts: 1,400
Joined: May 2016
Thanks: 1014
Given 1922 thank(s) in 741 post(s)
RE: New vibration damper?
Please be aware,
I was in no way trying to be insulting about correctly following the varyations of the procedures...DON'T be a Hammerhead!

I made this very mistake, and had to redo about 1/2 of a procedure. I now print the procedure off when I go to do something. Before I even put on my gloves or pick up a wrench, I sit down with said printout and review. I use a Sharpie to cross out the sections that DO NOT apply to me. I then highlight the headers of the ones that do. As I perform the procedure I have the printout on a clipboard and I "check" off the steps as I go so I don't be a Hammerhead again.

User's Signature: Why? Why do I always ask "why?" Because I can't learn or help teach others with "'cause I said so..."
Return to Top | find
replyreply
 Thanks given by: redbeard , Squish099 , hhow55 , Old Driver
new reply


Messages In This Thread
RE: New vibration damper? - Hammerhead - 05-23-2017



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication