Rawze.com: Rawze's ISX Technical Discussion and more / Big Truck Technical Discussion... / Ask Your question... / Is 4.3 V enough to power abs sensors?

new reply
Is 4.3 V enough to power abs sensors?
07-24-2017, (Subject: Is 4.3 V enough to power abs sensors? ) 
Post: #6
Kid Rock Offline
HMR- V.I.P  (102 Likes)  *****

 		Posts: 145
Joined: Feb 2016
Thanks: 267
Given 102 thank(s) in 47 post(s)
RE: Is 4.3 V enough to power abs sensors?
(07-24-2017 )Nilao Wrote:  Did you test each sensor pin to a ground? Just because it's in range doesn't mean one pin is not shorted.

Thats a good point I'll have to check in the morning. Still testing for ohms in the 900-2000 ohm range? ...On each pin to a good ground ok
Return to Top | find
replyreply
new reply


Messages In This Thread
RE: Is 4.3 V enough to power abs sensors? - Kid Rock - 07-24-2017



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.
Theme by MyBB Addict
Contact Us | Rawze.com | Return to Top | Return to Content | Lite (Archive) Mode | RSS Syndication