turbo lag and variation

[marek4792]

(09-05-2017 )Waterloo Wrote:  Also, make sure the Delta P sensor is set up properly, and you can do this now... From the Rawze @m*m^2 package of a few years ago... This is for the CM-871 only as far as I know, which is the motor I have.

on the CM870 the Delta P sensor with a jumper harness on it. The signal wire is pin #3 on the wiring diagram which i believe is the white wire looking at my truck. I'm not sure if it will make a difference on a demandated CM870 though as I pulled the middle pin(black wire) before looking at the wiring diagram (D'OH!) and no engine code present even when the sensor was throwing a code prior to being demandated.