CM 871 Injector Issue

new reply

Threaded Mode | Linear Mode

CM 871 Injector Issue

09-09-2017, (Subject: CM 871 Injector Issue )

Post: #4

graysonlogistics Offline

Contributing Member (4 Likes)

Posts: 9
Joined: Dec 2015

Thanks: 3
Given 4 thank(s) in 1 post(s)

RE: CM 871 Injector Issue

I only swapped the metering actuators. I replaced #1 and set the overhead. (Thanks for your videos by the way.) Still running rough, Did the cylinder test and the front bank failed. So, I will swap the timing actuators(which I should have done first) and see if the problem follows.

Return to Top | find

reply reply

« Next Oldest | Next Newest »

new reply

Messages In This Thread

CM 871 Injector Issue - graysonlogistics - 09-09-2017,

RE: CM 871 Injector Issue - Hammerhead - 09-09-2017,

RE: CM 871 Injector Issue - Rawze - 09-09-2017,

RE: CM 871 Injector Issue - graysonlogistics - 09-09-2017

RE: CM 871 Injector Issue - Hammerhead - 09-10-2017,

RE: CM 871 Injector Issue - snailexpress - 09-10-2017,

RE: CM 871 Injector Issue - graysonlogistics - 09-10-2017,

RE: CM 871 Injector Issue - Hammerhead - 09-10-2017,

NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.