CM-871 Overhead...
10-23-2017, (Subject: CM-871 Overhead... ) 
Post: #19
RE: CM-871 Overhead...
LOL! Thanks Rawze! I needed that! And yes, 8 nm, I already set up the torque wrench. My bad.
replyreply


Messages In This Thread
CM-871 Overhead... - Waterloo - 10-20-2017,
RE: CM-871 Overhead... - Rawze - 10-22-2017,
RE: CM-871 Overhead... - JMBT - 10-22-2017,
RE: CM-871 Overhead... - Rawze - 10-22-2017,
RE: CM-871 Overhead... - Waterloo - 10-23-2017
RE: CM-871 Overhead... - Rawze - 01-16-2018,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.