Here’s where I am at, what would you guys do? |
11-13-2017, (Subject: Here’s where I am at, what would you guys do? ) Post: #8 | |||
| |||
RE: Here’s where I am at, what would you guys do? (11-13-2017 )JMBT Wrote: Thanks for the input guys!! I figured you would all agree to change it, so I ordered the tool earlier today. It will be here Tuesday. I have the seal, dampner, crank sensor, a fan clutch rebuild kit, fan hub bearings, both belts, tensioners, and the AC idler pulley, all setting here in front of me ready to go! Both front and rear crank seals install dry, don't use any lubricant on it. Be sure to have the surfaces in the front structure and the crankshaft clean before installing seal and you'll be fine. | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
Here’s where I am at, what would you guys do? - JMBT - 11-12-2017, RE: Here’s where I am at, what would you guys do? - Squish099 - 11-12-2017, RE: Here’s where I am at, what would you guys do? - Jamescj212 - 11-12-2017, RE: Here’s where I am at, what would you guys do? - Waterloo - 11-12-2017, RE: Here’s where I am at, what would you guys do? - Rawze - 11-12-2017, RE: Here’s where I am at, what would you guys do? - Hammerhead - 11-12-2017, RE: Here’s where I am at, what would you guys do? - JMBT - 11-13-2017, RE: Here’s where I am at, what would you guys do? - Starlight - 11-13-2017 RE: Here’s where I am at, what would you guys do? - Hammerhead - 11-13-2017, RE: Here’s where I am at, what would you guys do? - Starlight - 11-13-2017, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.