Flywheel housing gasket replacement

[Hammerhead]

(01-06-2018 )mastergregor Wrote:  Quick question hammerhead, what did you use to jack up the rear of the motor to take the flywheel housing off? Single jack setup or some kind of double jack contraption? Also, where did you jack it up, on the oil pan flange or some place else? Thanks in advance.

I'm at moms for the w/end, I'll post pics of who, what, where, and how on Monday for ya.
But 2 bottle jacks, oil pan removed, and on the flat flange along where the pan would mount with thin wood shims so it's not steel on steel.
Because I have them, the jacks are on 4' long hernia blocks* to built a solid foundation as I have the truck up on 5" of blocks at the rear and on 8" of Jack stands on the front to make more room and working underside more conducive for a fat bastard with short arms...and to also make enough clearance to get the tranny out from under the truck to service it.

*Hernia blocks are 10" X 12" X4' hardwood blocks I use for loads that weigh 260# each, hence the term, they'll give you one if you aren't ready for it