Pulling Injectors on a 2250

[Rawze]

pulling injectors on a 2250 is very different than on a 871. Follow quickserv for the correct procedure and expect to replace the fuel feed tube that goes into the block if you loosen it, and definately if you replace the injector. They are not re-usable,are finicky, and will not re-seat very well after you loosen one. You end up with it failing a leak down test if it does not seat well.

perform a leak test BEFORE you pull any injectors, and again AFTER (once the engine has been up to temp and test driven under full operating load once) and compare the leak down rates.

<iframe id="lbry-iframe" width="560" height="315" src="https://lbry.tv/$/embed/isx-injector-leak-test-for-the-cm2250/e8187fb8d70f0f06388b597cb40751c5536d03dd" allowfullscreen></iframe>


As far as draining them, not sure. Have not don e a 2250 injector.