In-frame, what to do with ECM? Need guidance

[Waterloo]

(04-13-2016 )mkmac Wrote:  

(04-13-2016 )Waterloo Wrote:  My motor is coming along, hopefully be up and running by Friday this week. But, here is the question the owner of the dealership has asked me, and I don't know the answer.

When they near the end of the in-frame, they normally do their thing on the ECM with a clean program and whatever else they do. I have the @m*m^2 on there, and do not know how to proceed? I was going to ask Unilever to do a fine tune on her, but what do I tell, or allow the dealer to do? They know about the MM. Need some guidance here.

Tell them no need to reprogram the ecm,also on break-in Idle as little as possible Grab a loaded trailer the heavier the better and get her on a hill the longer the hill the better keep the rpm around 1500 and just work it just too make sure the rings set. always has worked for me .........

Will do, plenty of Honda motors to haul out of Detroit down to Indiana... About the only freight going right now.