Dyno Translation |
01-16-2018, (Subject: Dyno Translation ) Post: #12 | |||
| |||
RE: Dyno Translation Noticed something that aint the best. On the page that has the info from after the dyno run it shows oil pressure at 14 psi. Kinda low but the again it was idling below 600 rpm. Also it shows the percent load at 6%. Not good. You may have fueling actuators worn out or needing attention. | |||
|
« Next Oldest | Next Newest » |
Messages In This Thread |
Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - Rawze - 01-15-2018, RE: Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - the missing link - 01-15-2018, RE: Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - JMBT - 01-15-2018, RE: Dyno Translation - Grizzly - 01-17-2018, RE: Dyno Translation - Rawze - 01-15-2018, RE: Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - Rawze - 01-15-2018, RE: Dyno Translation - Grizzly - 01-15-2018, RE: Dyno Translation - Starlight - 01-16-2018 RE: Dyno Translation - Grizzly - 01-16-2018, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.