Low engine speed during high pressure test |
02-09-2018, (Subject: Low engine speed during high pressure test ) Post: #10 | |||
| |||
RE: Low engine speed during high pressure test basically all the tool is is a cap off for the rail to eliminate the fuel connector and injector for 1 cylinder. You just cap one off and run it and see if the return flow gets less/stops bypassing. then put on 2 of the block offs then 3 and so forth until you find the bad injector/tube etc. | |||
|
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.