radiator core ???

[Rawze]

(07-15-2018 )imalumberjack Wrote:  I worked in a radiator shop as a kid rebuilding semi truck radiators, back then we used cork gasket strips and ..... I think we just used a glue .... mainly to hold it in place for assembly ...then ran bolts through the holes with air gun. Make sure you mark the position of bolts that are different and if they face a different way. Its impairitive to put it back as it was. And don't over tighten!!!!!!! I didn't use a torque wrench .. just watched how much cork was pushing out, stop after movement. I got an hour to disassemble clean ends and reassemble with new core ......slave drivers!!!!!

A torque wrench would have been more consistent. I cringed when I saw "air gun" lol.