Help with pulling the programming from the ecm

[Evotrucker]

(08-04-2018 )snailexpress Wrote:  

(08-04-2018 )Evotrucker Wrote:  So I made it back to the shop to pull the programming from the ecm.... I'm on insite trying to find how and can't. I figured it would be intuitive. Uni told me to pull a file called C@ltr!m? Can someone tell me how or where this s.o.b is at.

Thanks ahead of time.

C@ltr!m is program to work with calibration file.
If you don't have C@ltr!m you can't. Uni can establish remote connection with yours ECM if you have Inline adapter.
Don't think Cummins shop will participate.

yeah after looking and looking, i figured it was software that wasnt on the laptop that i was using. ill have to look in C@ltr!m and see if i can install it on there laptop for one time use.

tho i am sure they have inline adapter, ill have to check with uni later on monday.

thanks bud!