Help with pulling the programming from the ecm

[Chamberpains]

Your gonna want to just hook up with Unilevers and let him pull the calibration. Because depending on your ECM and datalink connection you can be in for a very long in depth and often frustrating lesson in the computer side of your truck and the interface to your laptop if you go into this yourself. If I were you I'd just set up an appointment with him with the inline adapter Brock linked to and your laptop and just let him work his magic. I spent a little over a month tracking down and learning Calterm and how to sort of use it and I'm not to bad with computers.
Calterm is engineering software that was stolen and leaked all over the internet. So unless your connected to file sharing sites that host it or willing to take the 90% chance that a foreign country may sell the same stolen program with a wonderful virus attached, I again would just leave this knowledge up to the WhizKidz of this site. There prices are more than fair and they will inform you of any questions you have. Truly great guys.