My Pete rebuild

[Nostalgic]

(08-26-2018 )Pete379 Wrote:  What type of sleeving are you using with your harness? It’s hard to tell from the picture but I’ve always wondered if anyone used a different material then the split plastic from factory that seems to just fall apart after a few years

It's aluminumized high temp stuff from Mcmaster. I also got a stick of the high temp wrap for the new turbo speed sensor harness (mine was melted). I'm not sure I can put it together yet because I forgot to get fabric electrical tape. I'll have to run around a few hardware stores today to see if I can find any local.

Finding dual clamp cable ties was a challenge... I bought the short ones https://www.walmart.com/ip/Dual-Clamp-Ca...461930249, and I'm sure I won't have enough @ only a 10 pack.