Low boost PSI |
09-30-2018, (Subject: Low boost PSI ) Post: #29 | |||
| |||
RE: Low boost PSI (09-30-2018 )Diablo386 Wrote: Question Rawze...would I be able to send out ECM for you guys to look at it?? You did not mention what is failing during the calibration procedure other than saying it is not turning. What did Insite say? How about backing up the program that is in it then flashing it with the correct, original factory program listed on the data-plate for that ser# engine off quickserv and see if the turbo Actuator calibrates properly. - Bad / incorrect programming can make one not calibrate properly too. A lot of what you describe points right towards some typical bad delete programming issues. http://rawze.com/forums/showthread.php?t...5#pid29275 What I have suggested isn't rocket science, but it sounds like whoever your taking it to must think it is. User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!. | |||
« Next Oldest | Next Newest » |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.