IFSM Leaking
10-22-2018, (Subject: IFSM Leaking ) 
Post: #8
RE: IFSM Leaking
(10-21-2018 )berrytrucking94 Wrote:  cleaned everything up and ran it for a day. some fluid weeping from where the gear pump is mounted, but the timing actuator to the left of the shutoff solinoid is damp at the plug

tried ordering new plugs, is there a part# for these plugs? Tried looking on quickserve but couldn’t find a part#

Also, the actuator I replaced a few months ago has 2 pin holes in the front that weep fuel out of them??? The factory actuators don’t seem to have that. I’ve never seen it before, i swapped the metering/timing actuators from left to right tonight and that’s when I noticed the pin holes getting wet.

Attached are pics of the holes in the actuator..

The actuator is bad. Replace it!.

DO an injector leak tesrt while you at it. It might very well be that you have combustion gasses over-pressurizing the actuator and causing its demise!>




User's Signature: ->: What I post is just my own thoughts and Opinions! --- I AM Full Of S__T!.
replyreply
 Thanks given by: berrytrucking94


Messages In This Thread
IFSM Leaking - berrytrucking94 - 10-16-2018,
RE: IFSM Leaking - Rawze - 10-17-2018,
RE: IFSM Leaking - Rawze - 10-17-2018,
RE: IFSM Leaking - Rawze - 10-22-2018
RE: IFSM Leaking - Mr Hagg - 11-05-2018,
RE: IFSM Leaking - Unilevers - 01-25-2019,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.