Another oil pressure thread
11-17-2018, (Subject: Another oil pressure thread ) 
Post: #33
RE: Another oil pressure thread
I think we found the problem Rawze sir.

All main bearings plastigauge at .002
Rod bearings #’s 1-2-3 at .002
4 & 5 at .006 and # 6 at .002.

Going to reinspect crank jurnal and install .004 under rod bearings, plastigauge adding to verify .002 gap.
Close it up and heat cycle the motor. Fingers crossed


User's Signature: Have you checked your muffler bearings today?
replyreply
 Thanks given by: schISM


Messages In This Thread
RE: Another oil pressure thread - Peashooter67 - 11-17-2018
RE: Another oil pressure thread - Unilevers - 02-03-2020,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.