Tripac APU "Pre Evolution"

[Rawze]

(12-23-2018 )Lonestar10 Wrote:  Where is 8d and sd only find 8cp

wire "8P" (power to the solenoid) and "CH" (chassis ground) is the wire on the solenoid itself.

As far as the alternator connection goes, the 50Amp wire + the feed from that batteries both go to the main positive stud of the alternator. You should also have have +13v at "Power stud #2" in the pic above.

Wire "D+" goes form the board to the excitation circuit of the alternator. It should have power on it when the run relay engages along with the 8P circuit for the solenoid.