Bent rear axle?

[imalumberjack]

(01-02-2019 )Hammerhead Wrote:  

(01-01-2019 )imalumberjack Wrote:  Sooooo, cleaned everything and put it back together (what in the hell is that dumb sleeve for in between the bearings?) torqued to 200 ft pounds backed it off then torqued to 50ft pounds and it said to back off a quarter turn? seemed pretty loose then? slapped it together and spun it around ....no wobble ....I think it might have been the idiot (me) that put the tires on with an impact? maybe had them crossed up? have not went for a ride yet but I'm keeping my fingers crossed.

The hub is machined to specific depths and holds the outer races at a precise spacing.
The sleeve is machined to a specific length to properly space the INNER RACE of the bearing assembly.
THIS MEANS INSTALLATION IS DIFFERENT!!!

WITH THE SLEEVE, you torque the bearings to 200, back off, retorque to set the OUTTER RACE PRELOAD IN THE HUB, then you back off and retorque to spec (again usually 200) and lock the nut, THE SLEEVE SETS the inner race "spacing".

WITHOUT THE SLEEVE, is when you do the "back the nut off 1/4 turn and lock it." This part of the procedure sets the INNER RACE spacings WITHOUT the sleeve...

When I was reading instructions it said nothing about sleeve!!! I did not like the 1/4 turn back as it lost all preload!!!!! Thanks! looks like I will be doing it again.