Cummins ISX400, can`t install OEM ECM calibration!

[andreisana4]

(05-21-2016 )Nilao Wrote:  it should. We usually make a template using insite and then flash the ecm, then restore the template we saved which should tell the new calibration where to find everything. I have not had to do this personally, just recalling what I have read about it. An OEM calibration is a blank calibration as it is missing all the addressing.

Thank you, I sent to Ecm previous calibration's template everything is working fine now, no fault codes, and the right calibration is installed!