No start after actuator and fuel shutoff solenoid replaced |
02-01-2019, (Subject: No start after actuator and fuel shutoff solenoid replaced ) Post: #1 | |||
| |||
No start after actuator and fuel shutoff solenoid replaced Engine is Cummins ISX cm871 Can this fault cause low fuel rail pressure? (attached image) I put on new timing and metering actuators, and shutoff solenoid and got this fault, put old shutoff solenoid back on and still same issue. Voltage and ohm check out good. Lift pump is working, I am only getting 22psi when cranking but no start. Filters are new and filled with fresh fuel. Hopefully can figure this out before 5pm central time so I can order fuel pump if needed. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
No start after actuator and fuel shutoff solenoid replaced - Husky05 - 02-01-2019 RE: No start after actuator and fuel shutoff solenoid replaced - Nilao - 02-01-2019, RE: No start after actuator and fuel shutoff solenoid replaced - Rawze - 02-03-2019, RE: No start after actuator and fuel shutoff solenoid replaced - Nilao - 02-03-2019, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.