new speed sensor truck won't start?

[hosetrucking]

Figured out what happened, when I was routing the new wire down near the starter and then back to the end of the transmission my hand must have disconnected another wire connector. It's was buried and just luckily happen to see it.

On a side note, when I took out the Speedo sensor on the back of the transmission the sensor plastic housing broke off inside. Instead of taking off the rear yoke assembly I was able to take a mini butane torch with a 90 degree head and slowly burn and pick the plastic peices out with some long skinny needle nose pliers and a mirror to see inside the plug hole. Turing and annoying to perform but took only 30 minutes versus an hour or two wrestling off the driveshaft, yoke and rear transmission assembly. I did this on a truck with a lot of grout clearance and no crewmember, exhaust, or plumbing in the way. Hope that helps someone.