New Truck Purchase Any Advise

[JHNDZ]

(09-15-2019 )Rawze Wrote:  You also did not mention what the rear ratios are. I would not give 3 =cents for it if it is anything taller than about 3.55's. - Those damn mega-fleets any more spec these truck so wrong, where they eat the engine up due to too tall rears + low rpm hammering all the damn time, truck can hardly get out of their own way, it is not even funny any more. first half its life, some A-hole with his foot in the floor all the way against that governor lugging the crap out of the liners so that 500k later it is in dire need of an inframe because the dips#it thinks it can go up every hill below 1400 rpm everywhere they go without cutting engine life in half.


Pretty polish, false promises, and the glee of truck purchase blinds people so badly they have no clue what they are getting into. Is the truck even spec'd properly for what you plan on using it for? - Roof height, rear ratio, etc. etc. etc.

So far its only been a thought, that's why im here to learn what the community has to say. On there online pg it says it has 3.42 ratio. Its a 72 in sleeper , 230 wheel base . I plan on running the truck locally here in socal with a 53 ft dry van . adv 425 hp should be plenty i usually haul 20 - 25k lbs.