Possible head/valve problem
10-13-2019, (Subject: Possible head/valve problem ) 
Post: #25
RE: Possible head/valve problem
I set the overhead myself before i took it to them so it’s possible i left too much clearance. They also ran it on a dyno and the numbers came out real good. Boost pressure at 100% load was about 30 every time and the h20 was well within spec.
replyreply


Messages In This Thread
RE: Possible head/valve problem - Unilevers - 10-09-2019,
RE: Possible head/valve problem - Unilevers - 10-10-2019,
RE: Possible head/valve problem - Downthehaul - 10-13-2019



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.