Glowshift in cab Fuel Pressure Gauge?

[Rawze]

(10-22-2019 )Waterloo Wrote:  2008 ProStar, CM-871... Wondering if anyone has installed the Glowshift Fuel Pressure Gauge in the cab of their truck? It is electronic, not mechanical, wondering where the included sensor would go, or tap into the system at? Also, is 100 psi enough on the gauge? Isn't the pressure up in the thousands?

https://www.amazon.com/GlowShift-White-C...290&sr=8-7

On a CM870/CM871...

If u want to monitor the actual fuel pressure of the IFSM, you will likely need a 450+ psi hydraulic gauge (perhaps higher for cold weather?). - it usually hangs out at about 260-300 psi or so if memory serves me right.

- Personally, I see no point in putting one in unless you just looking to make the dash more cluttered.