N14 celect plus low voltage to pressure sensors

[Moose]

(11-03-2019 )wellrun Wrote:  Is it safe to connect the barometric and boost sensor from my temp sensor 5v suply

I wouldn't... Looking at it again check the wiring and any connectors going to the coolant level sensor. I'm looking at the diagram again and I cut it short. They show to use the same 5VDC supply & ground. I can remember some of the older resistor style level sensors would fail internally, leak coolant back into the harness and cause all kinds of gremlins.


  Celect_Plus_3666146_Rev_4.pdf (Size: 263.3 KB / Downloads: 298)