Cm871 coolant out the overflow

[Rawze]

WELCOME TO THE BAD DELETE CLUB!!!!!

YOUR FIRST PROBLEM IS THAT YOU WENT FOR DPF PROBLEMS TO ENGINE BUTCHERING BULLS$IT THAT THESE SHOPS LIKE TO ALL DO!!! -- YOU F#$#KIED UP!!!!!


START BY EDUCATING YOURSELF!!!!!

FIRST AND FOREMOST--- REMOVING THAT EGR COOLER, if they did not use a cross-pipe to allow for proper coolant flow where the cooler used to be (most shops are too stupid to do this the right ways), -- YOU ARE STARVING THE BACK 2 CYLINDERS OF PROPER COOLANT FLOW AND IT WILL GET HOT AND TAKE OUT A LINER AND HEAD GASKET!!! --- AND NOT ONLY THAT --- it will cause the water pump to fail prematurely due to the blocked off port on the back of it making 70+ PSI of dead water pressure in it!... I.E.> -- If you don;t have a bypass pipe installed ... then SOMEONE F$CKLED UP BY REMOVING THAT EGR COOLER OUT OF SHEER IGNORANCE -- I DON'T CARER HOW MUCH THOSE IGNORANT ARSSE-CLOWNS AT THAT SHOP THINK THEY KNOW!!!!!!

NEXT: YOU SHOULD BE SCARED!!! --- REALLY SCARED AT WHAT SOME FFFF MORON HAS DONE TO THE PROGRAMMING IN THAT ECM!!!--- GET THAT PROGRAM COPIED OUT OF THAT THING AND HAVE IT LOOKED AT A.S.A.P FOR CORRECTNESS AND SAFETY --- IT IS THAT IMPORTANT AS 90%+ OF ALL THESE SHOPS OUT THERE DOING THAT TYPE OF WORK ARE ABSOLUTELY FFFki' CLUELESS IGNORANT FOOLS!!!! -- E-MAIL IT TO ME AND I WILL LOOK IT OVER AND TELL YOU WHAT SOMEONE HAS DONE, GOOD, BAD, AND (USUALLY VERY MUCH, ENGINE DESTROYING) UGLY !!!.

--- START READING THE HORROR STORIES... AND START WORRYING!!!
YOUR EDUCATION START HERE!!!...
Here is the last one (cm871) I looked at just not even 4 days ago with someone. A fine example of how badly these things get butchered! - http://rawze.com/forums/showthread.php?t...2#pid46772

Here is the master collection of victims seen on this forum alone!!!...
http://rawze.com/forums/showthread.php?t...5#pid13255
(denial will only continue to cost you big $$$. Stop being a victim!).

--- LASTLY ..IT BEING A CM871 -- if your even a little bit computer savvy (able to run spreadsheets, install stuff on PC, etc)... YOU COULD HAVE DONE THE WHOLE GODDAMHN JOB YOURSELF -- FOR FREE!!!!! ---- PROPERLY!!! -- I HOPE YOU DID NOT PAY ANY KIND OF BIG $$$ MONEY FOR WHAT THOSE IDIOTS DID TO YOUR $40,000 COMMERCIAL ENGINE!!! -- WHAT A WASTE!!!

You have had nothing but problems out of that engine and truck -- BECAUSE YOU HAVE NOT EDUCATED YOURSELF ON HOW TO RUN AND MAINTAIN ONE PROPERLY AND HAVE DOEN NOTHING BUT RELYING ON IDIOTS SO FAR!!!

THAT CM871 IS THE MOST PROFITABLE ENGINE A PERSON CAN OWN RIGHT NOW...NOTHING CAN TOUCH IT ON LONG TERM PROFITABILITY, FUEL MILEAGE, ETC. WITH SOME PROPER EDUCATION, MAINTENANCE, AND OVERALL CARE !!!. -- STOP ABUSING IT AND TAKING TO PEOPLE WHO HAVE NO CLUE HOW TO WORK ON IT!!! -- GRAB A WRENCH AND GET BRAVE AND TAKE YOUR PROBLEMS INTO YOUR OWN HANDS AND SIOPP THE ENDLESS BLEEDING!!!.