Cam timing wedge spec

[Chamberpains]

(01-22-2020 )Signature620 Wrote:  If the angled face of the wedge is in full contact with the cam and the wedge is perfectly 90deg to the side of the head then it's in there right - No need for a height mark.

EDIT - I use the exact same wedges, made by Dave's Tools I think. They work fine.

Thanx
I used them in that exact way. And quickserve says the timing of the CM870 is "robust" enough to allow a good bit of variance. So I'm good to go. Cams are in place. But if someone has a measurement for the line, it'd be nice to make it for accuracy and quick checking.