Bad injector
01-26-2020, (Subject: Bad injector ) 
Post: #3
RE: Bad injector
I installed mine in my CM-871, it was not difficult at all. You will need to really read, and go over the procedures in Quickserve like hhow55 stated. If you have the tools for the overhead, you are already halfway there, but you may need a "special" tool to remove the injector. If a special tool is required to remove, it is probably worth the investment to purchase. Normally when one injector goes, the rest are soon to follow. At least that has been my experience.
replyreply


Messages In This Thread
Bad injector - Billy7871 - 01-26-2020,
RE: Bad injector - hhow55 - 01-26-2020,
RE: Bad injector - Billy7871 - 01-26-2020,
RE: Bad injector - Waterloo - 01-26-2020
RE: Bad injector - Billy7871 - 01-26-2020,
RE: Bad injector - tree98 - 01-26-2020,
RE: Bad injector - Magard - 01-26-2020,
RE: Bad injector - Billy7871 - 01-26-2020,
RE: Bad injector - tree98 - 01-26-2020,
RE: Bad injector - Lonestar10 - 01-27-2020,
RE: Bad injector - Waterloo - 01-27-2020,
RE: Bad injector - Billy7871 - 01-27-2020,
RE: Bad injector - JimT - 01-27-2020,
RE: Bad injector - dhirocz - 01-28-2020,
RE: Bad injector - Mr Hagg - 01-28-2020,
RE: Bad injector - Billy7871 - 01-28-2020,
RE: Bad injector - Mr Hagg - 01-28-2020,
RE: Bad injector - Billy7871 - 01-28-2020,
RE: Bad injector - Lonestar10 - 01-28-2020,
RE: Bad injector - Lonestar10 - 01-28-2020,
RE: Bad injector - JimT - 01-28-2020,
RE: Bad injector - Lonestar10 - 01-28-2020,



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.