ProStar CM871 Turbo (Before Milk2)

[D_Y_F_B_A_E]

(01-26-2020 )Brock Wrote:  

(01-26-2020 )D_Y_F_B_A_E Wrote:  What is a good tool to use, to hollow out my cans?
Should I use a hacksaw blade? Or would any sharp or blunt tool do the job?
Or maybe even my hand?

I don't even know what the material is that it's made out of.
I assume that it would be some sort of special fabric?

Crowbar or rebar and a hammer, punch your bar through all the way with the hammer then it will all start coming apart easy.

Thanks for the method!
Since I can't remove the DOC, do you think it would be okay to poke it through with the rebar as well, and then pull the pieces out?

Google Photos Link-> https://drive.google.com/open?id=153e7Hn...PCBgxuGwE_