2011 386 ultrashift swap to manual

[samrath]

(02-05-2020 )Signature620 Wrote:  Monitor vehicle speed with Insite. Is it reading more than 0 while moving? If not, then you will need to wire in a speed sensor to the rear of your transmission. I'm not from America, but all Paccar trucks I see with manual transmissions have 2 speed sensors - 1 for the cab and 1 for the engine.

If there is already 1 wired to the ECM, then make sure you have vehicle speed source set to magnetic in Insite.

I have same truck with a paccar engine 10 speed manual. But it only has one speed sensor. Is it possible that speed sensor wires are split from speed sensor to 4 wire to ecm