CM 871 Fault code 285

[2dlb]

(04-14-2020 )Rawze Wrote:  When it was re-flashed, it lost some features and parameters settings (the addresses for the switches) for those contorls - someone screwed up. Was a template made of the Features and Parameters before the reflash?. If so, then restore it.

I did get a work order made i think and went back at it tonight and as near as i can tell everything looks the same with the exception of 1 parameter that exists now that didn't before and that was for Aftertreatment Regen Start Switch. I am guessing that was because the old file was i think a mexican cal as this thing was demandated.