CAT ET Software (and head problems) |
05-07-2020, (Subject: CAT ET Software (and head problems) ) Post: #17 | |||
| |||
RE: CAT ET Software (and head problems) I did have all the rockers loose, and was loosing air, so that is why i pulled the head. I fully expected to see a burnt valve or something obvious, but there wasn't. I pressurized the head again after i took it off, and the leak wasn't nearly as bad. It would hold at 25 PSI. I just took the head to the machine shop where i bought it, to see if there was something i was missing. And maybe they're BS'ing me too!!! I'm going to go pick it up and check it out again. | |||
« Next Oldest | Next Newest » |
Messages In This Thread |
CAT ET Software (and head problems) - tsolson - 04-26-2020, RE: CAT ET Software - Rawze - 04-26-2020, RE: CAT ET Software - trucklogger2 - 04-27-2020, RE: CAT ET Software - Rawze - 04-27-2020, RE: CAT ET Software - tsolson - 04-30-2020, RE: CAT ET Software - Rawze - 05-01-2020, RE: CAT ET Software - tsolson - 05-01-2020, RE: CAT ET Software - tsolson - 05-03-2020, RE: CAT ET Software - tree98 - 05-03-2020, RE: CAT ET Software - tsolson - 05-03-2020, RE: CAT ET Software (and head problems) - tree98 - 05-04-2020, RE: CAT ET Software - Rawze - 05-04-2020, RE: CAT ET Software (and head problems) - Rawze - 05-04-2020, RE: CAT ET Software (and head problems) - tsolson - 05-06-2020, RE: CAT ET Software (and head problems) - Rawze - 05-06-2020, RE: CAT ET Software (and head problems) - tree98 - 05-06-2020, RE: CAT ET Software (and head problems) - tsolson - 05-07-2020 RE: CAT ET Software (and head problems) - tree98 - 05-07-2020, |
NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.