Leaking output shaft seal

[flatbed94kid]

I changed mine myself and it leaked again. Then hired some guys to do it and it leaked again!!!
What they did to get that nut loose is they used a torch to heat up the nut. Then a long breaker bar and pop it was loose. A good hot torch is your friend here.

You want to change the yoke as well bc the old one often wears a pattern in the old yoke seal like Chambers said and with a new seal it will leak again. Some reuse the big nut, some don't. Probably should add some red lock tite to it as well

My suggestion, get someone to do it.Unless your Rawze or Chamberpain.

Waterloo knows a guy who said there is a crush washer also. Was the reason why his was leaking. Also if your u-joints are pressed in they could be hard to pop loose. May change that u-joint while your at it or just check all the other joints as well. All new Driveline time! fun fun!