CM2250 ECM image down/upload help

[Rawze]

(09-07-2020 )lando3145 Wrote:  I'm trying to get familiar with Calterm and Ensite to work on a new to me truck. I think I found how to pull the cal files from the ECM but going through the process to upload to the ECM I am receiving errors. Anyone one who know and willing to share this knowledge is much appreciated.

Joe

Looked at his file today after he sent it to me. Typical bad delete just like the ones found being traded around on the auto/truck engine tuning sites.

Basically, it looks like someone dumped in a copied bad deelete out of another truck that is incompatible with his vehicle and changed the data plate info to match. - it is also quite bad, no engine mode control, bad detonation rate control, injection timing at 9+ degrees too high, etc.etc.etc.. and incomplete.