2011 Peterbilt 389 fuel won’t stay equal
09-30-2020, (Subject: 2011 Peterbilt 389 fuel won’t stay equal ) 
Post: #12
RE: 2011 Peterbilt 389 fuel won’t stay equal
its against DOT regs unless your truck is diesel. to many trucks hit stuff on the roads and dumped their fuel everywhere so i high recommend not even giving the thought another eyeota of time.


went read it i guess diesel tanks are exempt....ok but here it is.

Drains and bottom fittings.

(i) Drains or other bottom fittings must not extend more than three-fourths of an inch below the lowest part of the fuel tank or sump.

(ii) Drains or other bottom fittings must be protected against damage from impact.

(iii) If a fuel tank has drains the drain fittings must permit substantially complete drainage of the tank.

(iv) Drains or other bottom fittings must be installed in a flange or spud designed to accommodate it.

so if you can keep your fittings under 3/4 inch when measure from tank bottom to bottom of fitting then i guess it can be done.


User's Signature: 2010 Lonestar - CM871 - 13sp - 3.70s, 2016 T680 - cm2350 - 13sp - 3.36s - skateboarder
replyreply


Messages In This Thread
RE: 2011 Peterbilt 389 fuel won’t stay equal - Lonestar10 - 09-30-2020



NOTE: Rawze.com is not affiliated, nor endorses any of the google ads that are displayed on this website.