Coolant loss

[Chamberpains]

I've been meaning to post this for few weeks and this is the 1st story I've ran in to since that it applies.

Here in Central PA we actually have a journeyman machine shop that for a couple hundred bucks, will come to your chosen place and machine the counter bores to .014 They'll set the shims and liners to verify. I was told this is the only measurement they'll cut counter bores in an ISX. It seems the word is getting out that ISX's need to be set to this standard height.

A friend of mine told me that they do all the local dealerships and shops in the area when called. I was a bit surprised to hear this. It's good to know that there is a competent place doing this kind of work for guys. Maybe if this story goes south on an overhaul you can check your local area to see if there is a similar type of deal around. This will guarantee you get those counterbores done and done right.