Cm870 timing off??

[Waterloo]

(04-13-2021 )Nyluke124 Wrote:  How do i go about getting you that information do i need to get insite myself or is there another program i can use?

You will need Insite and an Inline reader. Maybe you can find a shop locally that can pull the file and put it on a thumb drive?

If you cannot, I would still order an Inline reader off of eBay, they are around $300 and include the software. In the mean time, I would take the truck to a dealership and have them flash the ECM to the latest factory program.

As long as you have the EGR valve installed, and no one swapped out the factory turbo, you should be OK.

Hopefully they did not plate anything else off or drill holes in the block.

Have the dealer look over the motor to make sure nothing stupid has been done prior to flashing the ECM. Tell them you suspect it has a delete and you want it fixed.

Hopefully there is a real mechanic there that knows what to look for.

If not, bobtail it to Griffin GA and have it repaired correctly at Mr Haggs.

Personally, take it to Mr Hagg, that way, there are no unanswered questions left on the table. A few dollars in fuel and a few hours of your time, your call.

A lot of "Hope" going on in this post... Until you get to GA and have it fixed correctly.