New Clutch No Power now at Random

[BigOlDog]

Update.

Fuel lines are good. Speed sensor still questionable for this post.

We are now getting a engine intake manifold pressure #1 code (102). We’ve replaced sensor, checked wires that were exposed wrapped them back up, replaced turbo actuator put nearly 400 miles on the truck before power lost again. It feels like dead pedal. The truck goes but has no torque. When loaded it will go but a complete struggle. Loaded or unloaded when in this no power mode no power through the entire RPM range.

I’m sure you wonder how this goes from clutch and no power but I’m just sharing what was done then this started showing up.. We have checked the fuel system, replaced filters did find some trash... Blew back into the tanks to make sure we didn’t have more.

We are lost in a solution, thanks for the help!